Table of Contents
Advertisement
Other Useful Features
• When connecting an IVA-D300 series to the TME-M770, be sure to connect it to the "AUX IN 1" connector and set the
"AUX IN MODE" setting (SETUP) to "LINK".
• When connecting a DVA-5210, DHA-S680 series, etc., to the TME-M770, set the "AUX IN MODE" setting (SETUP) to
"EXT.DVD".
• When connecting a TV tuner to the TME-M770, set the "AUX IN MODE" setting (SETUP) to "TV".
• The TME-M770 and other components connected to it can be operated with a separately sold remote control unit. For
instructions on operations using the remote control unit, see the remote control unit's operating instructions. When
operating an IVA-D300 series, see the "Rear Entertainment Function" section of the IVA-D300 series's operating
instructions.
• Depending on the connected component, some functions and operations may differ. Also refer to the operating
instructions of the connected component.
Information
In Case of Difficulty
If you encounter a problem, please review the items in
the following checklist. This guide will help you isolate
the problem if the unit is at fault. Otherwise, make sure
the rest of your system is properly connected or consult
your authorized Alpine dealer.
No function or display.
• Car's ignition is off.
- Turn the ignition on.
• No fuse or blown fuse.
- Check the cause and replace the fuse.
• Incorrect connections.
- Check connection and remedy.
• Vehicle's battery is weak.
- Check the voltage of vehicle's battery.
Unclear picture display.
• Fluorescent tube is exhausted.
- Replace the fluorescent tube*.
No picture display.
• Brightness control is set for minimum brightness control.
- Adjust the brightness.
• Incorrect setting of the VTR mode.
- Switch to the correct mode.
• Protective circuit is on because of high temperature.
- Wait until the temperature inside the vehicle comes
down to the operating temperature range (45°C).
• Incorrect or open connection with the Monitor, AV
interface unit.
- Check the connection and remedy.
Picture color is poor.
• Brightness/Color/Tint control are not set to the proper
positions.
- Check each control.
Spots or dotted lines/stripes appear.
• Caused by neon signs, high-voltage power lines, CB
transmitter, other vehicle's ignition plugs, etc.
- Change the location of your vehicle.
Unit does not operate.
• Monitor's power is not turned on.
- Turn on the monitor's power.
10
-EN
Navigation screen is not displayed or navigation
system's remote controller keys do not work.
• Navigation system's power is turned off.
- Press the ON/OFF (POWER) button on the navigation
system's remote controller to turn the navigation
system's power on.
* The fluorescent tube replacement is not free of charge
even within the warranty period, for the tube is an article
of consumption.
Specifications
MONITOR
Screen Size
Display System
Drive System
Number of Picture Elements
Effective Number of Picture Elements 99.99% or more
Light Source
Dimensions (W x H x D)
Weight
AV Interface Unit
Dimensions (W x H x D)
Weight
• Due to continuous product improvement,
specifications and design are subject to change
without notice.
• The LCD panel is manufactured using an extremely
high precision manufacturing technology. Its effective
pixel ratio is over 99.99%. This means that there is a
possibility that 0.01% of the pixels could be either
always ON or OFF.
6.5-type
Low reflection rear
projection type TN liquid
crystal panel
Active matrix drive,
normally white display
280,800 pcs. (H:1200 x
V:234 dots)
Internal optical system (U-
type cold cathode fluorescent
tube)
161 x 109 x 28.5mm
360g
180 x 119 x 28.5 mm
550g
Advertisement
Table of Contents
