Section 5: Maintenance & Lubrication
Zerk Located through slot in tube
8-10 pumps
4-5 pumps
4-6 pumps
2-3 pumps
Figure 5-8
34
RC2512 Rotary Cutter 330-725M
Table of Contents
CV Main Driveline Profile Tubes
CV = Constant Velocity
Type of Lubrication: Multi-purpose Grease
Quantity = Coat Generously
30636
IMPORTANT: To extend the life of the constant
velocity joint, the grease zerk for the profile tubes
must be lubricated every 8 hours.
2-3 pumps
Constant Velocity Main Driveline Joints
Type of Lubrication: Multi-purpose Grease
For instructions on how to access grease zerks shown
in Figure 5-8, see "Accessing CV Driveline Joints" on
30636
page 35.
IMPORTANT: To extend the life of the constant
velocity joint, extensive lubrication must be
performed every 8 hours of operation.
•
The constant velocity joint should be greased in a
straight position forcing grease through the passages
and into the cavity. After lubrication, grease should
be visible around the ball joints.
•
Grease fittings located on the u-joints should be
lubricated every 8 hours of operation.
8
Hrs
8
Hrs
3/27/15