Advertisement
PC MONITOR MODE
---------------------------------------------------------------------------------------------------
Connecting a PC
1
Connect the »PC-IN« socket on the television
to the corresponding socket on the PC using
a VGA cable (video signal).
Connect the
»PC
Audio« socket on the tel-
2
evision to the corresponding socket on the
PC using a suitable cable (audio signal).
Note:
Adjust your PC to the monitor (for example,
7
picture resolution 1280 x 768, picture fre-
quency 60 Hz).
Selecting presets for the PC
1
Press »AV« and use »
«, »
«, »
<
« or »
>
«
V
Λ
to select the preset »PC« and press » « to
confirm.
Settings for PC mode
1
Open the menu with »i«.
2
Select the »SOURCE SETUP« menu item with
»
« or »
« and press » « to confirm.
V
Λ
– The »SOURCE SETUP« menu appears.
3
Select the function or setting with »
« or
V
»
«, and then use »
«, »
« or »
<
«, »
>
« to
Λ
V
Λ
implement it.
Options:
– »Auto Ajust« for automatic PC configura-
tion.
– »Auto Ajust Mode«, select the option
»On« if the configuration should be imple-
mented automatically in PC mode.
– »Position« to configure the horizontal and
vertical picture position.
– »Size« to set the cycle frequency.
– »Phase« to eliminate flicker, unfocused
pictures or horizontal interference.
4
Press »
i
« to end the setting.
67
ENGLISH
INFORMATION
---------------------------------------------------------------------------------------------------------------------
Displaying signal information
(for digital channels only)
1
Open the menu with »i«.
2
Select the line »SOURCE SETUP« with »
«
V
or »
« and press » « to confirm.
Λ
3
Select the line »Signal Information« with
»
« or »
« and press » « to confirm.
V
Λ
– Information on the channel, network,
modulation, symbol rate, quality and
signal strength is displayed.
Notes:
The signal information changes in ac cord-
7
ance with the current input source.
The signal properties are displayed in the
7
lower section of the menu. The further the
bars for »Quality« and »Signal Strenght«
extend to the right, the better the reception
signal.
The signal level not only depends on your
7
receiver system, but also on the channel
which is currently active. Remember this
when aligning your antenna based upon
the signal level display.
i
4
Press »
« to close the menu.
78
ENGLISH
Pre-programming the remote
control for other GRUNDIG
devices
»DVB« has been pre-programmed for op er-
7
ating a GRUNDIG digital receiver (remote
control level 1).
»DVD« has been pre-programmed for oper-
7
ating a GRUNDIG DVD player.
»AMP« has been pre-programmed for oper-
7
ating a GRUNDIG AV receiver.
The functions available depend on the
7
model of the device you are using. Just try
it out.
Changing the pre-programming
of the remote control
1
Press and hold »M« and simultaneously
enter the three numbers of the corre sponding
code:
»1«, »2«, »3« for a GRUNDIG DVD player.
»4«, »5«, »6« for a GRUNDIG DVD recorder.
»1«, »4«, »7« for a GRUNDIG digital
receiver (remote control level 1).
»2«, »5«, »8« for a GRUNDIG digital
receiver (remote control level 2).
»3«, »6«, »9« for a GRUNDIG digital
receiver with a hard disk (PDR).
Advertisement
