Table of Contents
Advertisement
Appliance installation
Appliance installation
Installation steps
1. Installing the expansion-bolt hooks
Cube type
Drill two Φ 10mm x 85mm holes in the wall as shown in the figure. Insert the
expansion pipe into the hole, put the screw through the hanging plate, and tighten
the screw with a screwdriver, and the hanging plate direction is vertical upward (as
shown in the figure).
Slim type
Drill three Φ 10mm x 85mm holes in the wall as shown in the figure. . Insert the
expansion pipe into the hole, put the screw through the hanging plate, and tighten
the screw with a screwdriver, and the hanging plate direction is vertical upward (as
shown in the figure)
16
Advertisement
Table of Contents
