Installation Steps - Viessmann VITOWELL comfort Installation And Operation Manual

Appliance installation
The appliance should be installed not too far from the point of use to limit heat dispersion along the piping.
Allow for a clearance of at least 50 cm to provide access to the electrical components, thus facilitating the maintenance
activities.

Installation steps

Cube type
1. Installing the expansion-bolt hooks
Drill two ø10 x 85 mm holes in the wall. Insert
expansion tubes into the holes, place the screws
through the hanging plate, and tighten the
screws with a screwdriver. Ensure hanging plate
is positioned vertically upward.
2. Remove baffles plate from hanging holes
Pry up the plastic baffle plates on the back of the
water heater that are covering the hanging holes
with a slotted screwdriver. Keep hanging holes
visible.
3. Hanging water heater
Lift the water heater, align its hanging holes with the hanging plate hooks. Fit the hanging holes onto hanging
plate hooks. Pull down the water heater to ensure secure installation.
Clearance space should be provided around the water heater as shown in the figure, to facilitate installation
and maintenance operation.
≥ 80mm
≥ 80mm
≥ 160mm
≥ 80mm
7