ADT K5309V2 User Manual page 7

Phone Access
If included, a phone module permits you to access the system via a touch-tone
phone, either on-premises or by call-in when away.
When you call in, the phone module announces system status over the telephone,
and you can arm/disarm the system and perform most function commands
remotely using the telephone keys.
Complete information for using these features is provided with the voice module.
Paging Feature
If programmed, the system can automatically send certain system condition
messages to up to four pagers.
The display consists of code numbers that identify the type of condition that has
occurred.
Scheduling
Your system can be programmed to automatically perform certain functions (e.g.,
arm the system) at a predetermined time each day.
The Voice Touchpads feature a voice message
center that lets you record and playback one
message.
The message can be up to 2.5-minutes long
The message remains in the Touchpad's memory
until a new message is recorded.
The volume control of the message is adjustable.
Refer to the procedures below when using the
Message Center functions.
Message Center Functions
To... Press these keys...
record a
[#] FUNCTION + [0] VOICE + [1] RECORD
message
end
[1] RECORD
recording
play a
[#] FUNCTION + [0] VOICE + [3] PLAY
message
adjust the
[#] FUNCTION + [0] VOICE + [2] VOLUME keys,
volume
then press volume key [3]
SPEAKER
LEDs
MICROPHONE
Notes...
The red MESSAGE LED lights.
Message remains in memory
until a new message is recorded.
The red MESSAGE LED flashes,
indicating message waiting.
The recorded message plays and
the red MESSAGE LED turns off.
Adjusting message volume also
adjusts status volume. Volume
(up) or [6] (down)
cannot be adjusted while playing.
LCD RECORD VOLUME
DISPLAY KEY KEY UP VOLUME
1
2 3
ARMED OFF
AWAY STAY
RECORD VOLUME PLAY
4 5 6
READY TEST BYPASS
8 9
MESSAGE 7
INSTANT CODE CHIME
0 #
MIC
READY
STATUS VOICE FUNCTION
STATUS VOICE FUNCTION
KEY KEY KEY
PLAY KEY
AND
DOWN
VOLUME
– 7 –