Pedal/Slider Filters (Tr) - Roland RD-170 Owner's Manual

RD-170 Edit parameters and Setup memories
(2) Press the [UPPER] (red) or [LOWER] (green)
button to select the part whose setting you
want to change.
(3) Use [DEC÷NO]/[INC÷YES] to set the send level
value (0~127). Simultaneously press [DEC÷NO]
and [INC÷YES] to select off if the selected
part should not transmit any CC93 value
when you select the Setup memory in ques-
tion (this is the default setting).
(4) Press [EXIT] (or [EDIT]) to leave the Edit mode
or select the other part and change its setting
too.
Note: This setting can be saved (see p. 28).
Note: If there is no audible change, you may have to
check the Chorus effect settings on the receiving MIDI
instrument.
Note: Not all MIDI instruments have a Chorus effect
and even if they do, they may not support this control
change number (this is especially true of older instru-
ments).
26

Pedal/slider filters (TR)

Here are three parameters that allow you to specify
whether (on) or not (off) the damper pedal, foot-
switch (or expression pedal) and/or PART LEVEL slid-
ers should transmit (TX) the corresponding MIDI
messages:
[10] CC64
Footswitch connected to the PEDAL
DAMPER socket.
[11] CC66
Sostenuto
CC67 Soft
CC11 Expression
Footswitch or pedal connected to the
SOFT/EXPR. socket. Its function depends
on the setting selected for "Second
pedal" (p. 22) and "Pedal detection"
(p. 30).
[12] CC07
PART LEVEL sliders
(1) Press [EDIT] (lights), followed by [10], [11] or
[12].
off
Sustain tr
2nd pedal tr
Slider tr
Press and hold the numeric button in question
to display the abbreviated function name.
(2) Press the [UPPER] (red) or [LOWER] (green)
button to select the part whose setting you
want to change.
(3) Use [DEC÷NO]/[INC÷YES] to select on (transmit)
or off (do not transmit).
(4) Press [EXIT] (or [EDIT]) to leave the Edit mode
or select the other part and change its setting
too.
Note: This setting can be saved (see p. 28).
→[MIDI]