Setting Advanced Functions - Omron H7BX Manual

When using the H7BX as a Total and Preset Counter, Batch Counter, Dual Counter, or Twin Counter, switch the configuration using the
procedure on page 33.

Setting Advanced Functions

Settings that cannot be performed with the DIP switch are performed with the operation keys.
Power ON
*1 *2
3 s min. 3 s min.
cntm
Input mode
(CNTM)
up
outm
Output mode
(OUTM)
n
otim
Output time
(OTIM)
0.50
cnts
Counting
speed
30hz
(CNTS)
iflt
Min. reset
period
20ms (IFLT)
Decimal point
position
(DP)
Prescale
value
(PSCL)
imod
NPN/PNP
input mode
npn
(IMOD)
From next page To next page
For details on operations and display in run mode, refer to page 15. The display depends on the configuration used.
*1. If the mode is switched to the function setting mode during operation, operation will continue.
*2. Changes made to settings in function setting mode are enabled for the first time when the mode is
changed to run mode. Also, when settings are changed, the counter is reset (present value initialized
and output turned OFF) on returning to run mode.
The characters displayed in reverse video are the default settings.
When performing settings with operation keys only, turn OFF pin 1 of the DIP switch (factory setting).
If pin 1 of the DIP switch is ON, the setting items indicated by
*3
· Set the input mode with any of the
*5 *5
up down ud-a
(DOWN) (UP/DOWN A)
(UP)
Note: Displayed only when Twin Counter Mode is not selected.
*5. Displayed for output modes other than K-2, D, L, and H only.
· Set the output mode with any of the
(N) (F) (C) (R) (K-1)
*6. k-2, d, l and h are displayed only when the H7AN compatibility
function is off or the input mode is ud-a, ud-b, or ud-c.
(Not displayed when the function is set to twn.)
H is displayed only for 2-stage models.
*7
· Set the number for each digit with the
(0.01 s) (0.50 s) (99.99 s)
Note: Displayed only when the output mode is C, R, K-1, P,
Q, A, or K-2.
· Set the counting speed with any of the
30hz 5khz
(30 Hz) (5 kHz)*
* The display shows 5 kHz, but the maximum counting speed is 10 kHz.
· Set the min. reset input signal width with any of the
20ms 1ms
(20 ms) (1 ms)
· Set the decimal point position with any of the
No decimal One digit after
point decimal point
Note: Not displayed when the H7AN compatibility function is ON.
· Set the number for each digit with the
(0.001) (1.000) (99.999)
Note: Not displayed when the H7AN compatibility function is ON.
· Set the NPN/PNP input mode with any of the
(NPN (PNP
input) input)
will not be displayed.
Keys.
Up
*5
ud-b ud-c ud-d ud-e
(UP/DOWN B) (UP/DOWN C) (UP/DOWN D) (UP/DOWN E)
Keys.
Up
*6 *6
(P) (Q) (A) (K-2) (D)
Keys.
Up
*7. Set the number for each digit with the
● 2-stage Preset Counter
Keys.
Up
Keys.
Up
● Batch Counter
Keys.
Up
● Twin Counter
Two digits after Three digits after
decimal point decimal point
Keys.
Up
Keys.
Up
*3. When using as a dual counter
Dual count
calm
*5 *5
calculating mode
ud-f
(ADD)
add
(UP/DOWN F)
·
Set the dual count calculating mode
the Key.
Up
*4
(Addition)(Subtraction)
*4. Displayed only when the output
mode is K-2, D, L, or H.
*6 *6
Usage as a Decrementing
(L) (H)
Counter (5ub)
The 5ub parameter is normally
not displayed. You must set the
outm parameter shown below in
advance to *6 (k-2, d, l, or h)
to display it.
Up
otm2
Output 2
time
(0.01 s) (0.50 s) (99.99 s)
(OTM2)
0.50
Note: Displayed only when the
output mode is C, R, K-1,
P, Q, A, or K-2.
otm1
Output 1
time
(OTM1) (Outputs held) (0.01 s) (99.99 s)
hold
If the output time is 0.00,
hold is displayed.
Note 1: Displayed for output
modes other than D, L,
and H.
Note 2: HOLD cannot be set
when the output mode
is K-2.
otm2
Output 2
time
(0.01 s) (0.50 s)(99.99 s)
(OTM2)
0.50
Note: Displayed only when the
output mode is C, R,
K-1, P, Q, A, or K-2.
Output 2
otm2
0.01 0.50
output
time
(0.01 s) (0.50 s) (99.99 s)
0.50
(OTM2)
Note:Displayed only when the
output mode is C, R, K-1, P,
Q, or A.
otm1 Output 1
0.01 0.50
output
time
(0.01 s) (0.50 s) (99.99 s)
hold
(OTM1)
Note:Displayed only when the
output mode is C, R, K-1, P,
Q, or A.
H7BX
Keys.
99.99
99.99
10