3 Attach the controller holder, and insert the controller
1
Velcro fasteners
4 Put the backrest cushion in place
5 Connect the power cord to the unit
Appliance inlet
Power cord
Power switch section
Connector
9
9-10
2
1
Check for dirt and damage on
appliance inlet of the power switch
section and the connector of the
power cord.
2
Insert the connector into the appliance
inlet.
3
Be sure to push the connector in all
the way.
BEFORE EVERY MASSAGE (CHECK THE UNIT)
Unfasten the zippers
(3 locations) and fold
down the back pad
Check
Check
1
Remove the backrest cushion.
2
Make sure there are no tears or rips in
the fabric.
See Caution No. 10 on page 2.
3
Make sure the massage heads are in
the retracted position and then replace
and fasten the back pad.
See Caution No. 3 on page 2.
When the massage heads are not in the retracted
position
•
After step 7, press the
button on the controller
twice to return the massage heads to the retracted
position.
2010/01/20
10
13:28:50