How To Change A Discrete Parameter - HP 8163A User Manual

Getting Started
How to Change the Value of a Parameter
5 When you have finished editing the value, press E
edited value becomes the new value of the parameter.
To change the wavelength from 1540.000 nm to 1525.000 nm:
1 Move to the wavelength parameter for a Tunable Laser module
and press [Edit]. The most significant digit is highlighted.
2 Press the left cursor once to highlight the digit four.
3 Press the down cursor twice to change the value of the digit to
two.
4 Press the right cursor once to move the cursor one digit right.
5 Press the up cursor five times to change the value of the digit to
five. Press E
NTER

How to Change a Discrete Parameter

For discrete parameters, you may choose a particular values within
a given range.
For a Power Sensor module:
1 Move to the Power Sensor channel and press the [Details]
softkey.
2 Move to the [A
VG
3 Move to 1 s, by using the cursor key, and press E
or
1 Move to the Power Sensor channel and press the [Menu] softkey.
2 Move to the <A
VERAGING
You see the screen in Figure 1-16.
3 Move to <1 s>, by using the cursor key, and press E
44
to end the editing.
T ] parameter and press E
IME
T > parameter and press E
IME
. The
NTER
.
NTER
.
NTER
.
NTER
.
NTER