Advertisement
Step Three
Ensuring the holes along the centre rail (7) are facing upwards, attach to the underside of Tubing Slats (5) using
M6 x 35mm Bolt (D) and M6 Nut (E). Screw the adjuster (F) fully into the bottom of the supporting legs (6).
Attach the supporting legs (6) into the pre - drilled holes on the under side of the centre rail (7) using
M6 x 35mm Bolt (D) and M6 lock nut (I).
F
6
Note: Once the supporting legs are secured in place, unscrew the adjuster (F) slightly, ensuring there is a small
gap of 5mm in between the adjuster (F) and the hard point of the floor.
Step Four
Starting at the headboard (I), attach the centre plastic holders (G) into the holes along the centre rail (7) Ensuring the
wooden slats (4) has the curved side facing up, place the side cap (H) onto one end of the wooden slats (4). Insert the
other end of the wooden slat (4) into the centre plastic holder (G), then insert the side cap (H) onto the side rail (3) into
the pre-drilled holes. Repeat this process for all the wooden slats on both sides of te centre rail.
I
This bed is now ready to use.
7
6
4
G
3
4/5
G
3
J
D
E
J
H
Advertisement
