Alarm Relay Contacts; Ex9200-2C-8Xs Line Card; Line Card Models; Figure 14: Alarm Relay Contacts In Ex9200 Switches - Juniper EX9200 Manual

Alarm Relay Contacts

Related
Documentation

EX9200-2C-8XS Line Card

Line Card Models

Copyright © 2016, Juniper Networks, Inc.
The craft interface has two alarm relay contacts for connecting the switch to external
alarm devices. Whenever a system condition triggers either the critical (major alarm) or
warning (minor alarm) alarm on the craft interface, the alarm relay contacts are also
activated. The alarm relay contacts are located on the upper right of the craft interface.
Figure 14 on page 25 shows the alarm relay contacts in EX9200 switches.

Figure 14: Alarm Relay Contacts in EX9200 Switches

Alarm
relay
contacts
Craft Interface panel
EX9204 Switch Hardware Overview on page 69
EX9208 Switch Hardware Overview on page 81
EX9214 Switch Hardware Overview on page 91
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces in a single assembly. Line cards are field-replaceable units (FRUs) that you
can install in the line card slots on the front of the switch chassis. Line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
This topic describes:
Line Card Models on page 25
Line Card Components on page 26
Table 13 on page 26 shows the model number, description of the line card model, and
the Junos OS release in which the line card was first supported.
Chapter 2: Updated Common EX9200 Topics
25