Table of Contents
Advertisement
All manuals and user guides at all-guides.com
GENERAL INFORMATION
IMPORTANT:
PLEASE NOTE THAT THE
VOLTAGE SELECTOR
LOCATED AT THE REAR OF
THIS SYSTEM IS PRESET AT
220V FROM THE FACTORY.
FOR COUNTRIES THAT
OPERATE AT 110V, PLEASE
ADJUST TO 110V BEFORE YOU
SWITCH ON THE SYSTEM.
General Information
• The type plate (which contains the
serial number) is located at the rear
of the system.
• Recording is permissible if
copyright or other rights of third
parties are not infringed.
Environmental Information
All unnecessary packaging has been
omitted. We have tried to make the
packaging easy to separate into three
materials: cardboard (box), polystyrene
foam (buffer) and polyethylene (bags,
protective foam sheet).
Your system consists of materials which
can be recycled and reused if disassembled
by a specialized company. Please observe
the local regulations regarding the disposal
of packaging materials, exhausted
batteries and old equipment.
Untitled-2
5
SAFETY INFORMATION
Energy Star
Safety Information
• Before operating the system, check that
the operating voltage indicated on the
typeplate (or the voltage indication
beside the voltage selector) of your
R
system is identical with the voltage of
As an ENERGY STAR
Partner; Philips has
determined that this product meets the
your local power supply. If not, please
R
ENERGY STAR
guidelines for energy
consult your dealer. The typeplate is
efficiency.
located at the rear of your system.
• When the system is switched on, do not
move it around.
Acknowledgement
• Place the system on a solid base (e.g. a
cabinet).
• Place the system in a location with
adequate ventilation to prevent internal
heat build-up in your system. Allow at
Dolby Pro-Logic and the double-D symbol
least 10 cm clearance from the rear and
d are trademarks of Dolby Laboratories
the top of the unit and 5 cm from the
Licensing Corporation.
each side.
Manufactured under license from Dolby
• The system incorporates a built-in
Laboratories Licensing Corporation.
safety feature that prevents
overheating.
Accessories
(Supplied)
• Do not expose the system to excessive
– Remote control
moisture, rain, sand or heat sources.
– Batteries (two AA size) for remote
• Under no circumstances should you
control
repair the system yourself, as this will
– AM loop antenna
invalidate the warranty!
– FM wire antenna
– AC power cord
– CS-340 speaker package (includes one
pair of surround speakers and one
center speaker)
• If the system is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may
condense on the lens of the CD unit
inside the system. Should this occur, the
CD player will not operate normally.
Leave the power on for about one hour
with no disc in the system until normal
playback is possible.
• Electrostatic discharge may cause
unexpected problems. See whether
these problems disappear if you unplug
the AC power cord and plug it in again
after a few seconds.
• To disconnect the system from the
power supply completely, remove
the AC power plug from the wall
socket.
6/8/01, 10:12 AM
5
3139 116 19782
Advertisement
Table of Contents
