Before You Begin - Razor Sonic Glow Owner's Manual

BEFORE YOU BEGIN

HEADLINE
Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during
shipping. Because the scooter was 95 percent assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 4 for charging information).
Throttle
Collar Clamp
Limiter
ON/OFF Switch
Required Tool
5 mm Allen Wrench
(included)
Charger
(Note: Charger design may
vary from one shown)
1.
Power Cutoff Rear-Fender Brake
2.
Battery
Charger Port
3 3
3.
Hub Motor
Control Module
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
ELECTRIC SCOOTER. The scooter
has been built to certain Razor
design specifications. The original
equipment supplied at the time
of sale was selected on the basis of
its compatibility with the
frame, fork and all other parts.
Certain aftermarket products
may not be compatible and will
void the warranty.
Note: Electric scooter must be
moving at least 3 mph (5 km/h)
while pressing the throttle to
engage motor.
Product ID Locations:
(See locations to the left)
1. Handlebar Stem
2. Underneath Battery Tray
3. Charger
4. UPC Side of Box (Not Shown)
Box Contents:
• Electric Scooter
• Charger
• Allen Wrench
• Owner's Manual