Ricoh Pro C9200 Manual page 42

2. Troubleshooting
If the print defect notification keeps appearing even after you have carried out the procedure given
below, contact your service representative.
1. In [Threshold Settings]
2. Print a copy again.
• If you change [Detection Level Settings], the changed setting is applied to all the jobs to which
the preset is applied.
3. If the print defect notification keeps appearing on the Image Quality Monitor console, check the
area of the print defect.
1 1
2 2
3 3
4 4
1. Area within 50 mm (2.0 inches) of the top edge of the paper
2. Area 150 to 200 mm (5.9 to 7.9 inches) from the bottom edge of the paper
3. Area 30 to 60 mm (1.2 to 2.4 inches) from the bottom edge of the paper
4. Area within 25 mm (1.0 inch) of the bottom edge of the paper
If defect is in area 1
1. If the paper length is greater than 488 mm (19.2 inches), adjust the value in [Motor Speed:
Fusing Belt] in "Custom Paper Settings" in steps of 0.5% (max: 3.0%; min: -3.0%). Start by
increasing the value.
For details about custom paper settings, ask the machine administrator.
40
M0B1IC8003
[Detection Level Settings], reduce the detection level.
M0B1IC0009