Table of Contents
Advertisement
2.3
Wiring of Transceiver Unit
Fabrication of cable TTYCY-3S, 65S1213/65S1239
Cut the cables to fix them at the plate in the unit with a cable tie, leaving some slack for
servicing and checking ease. Shield wire should be fixed at the plate. Twist pair cables together
before connecting to the board.
Anticorrosive Sheath
Secure armor by clamp.
Rubber Gasket
When using the optional junction box, fabricate the cable same as the above figure.
Transceiver unit, inside view 1
160
145
5 10
Shield
Vinyl Sheath
Armor
Fixing plate
Cradle
Washer
Fabrication of cable TTYCY-3S
Terminal board
26
Crimp-on Lug
FV2-M4
Fasten the shield together with
the fixing plate on the cradle.
Cable gland
(for TTYCY-3S)
Transceiver unit, inside view 2
Fixing plate
Lay the shield of cable,
and then tighten.
Advertisement
Table of Contents
