Sony DVP-NS300 Operating Instructions Manual page 62

xDIGITAL OUT
Selects if audio signals are output via the
DIGITAL OUT (COAXIAL and OPTICAL)
jacks.
ON
Normally, select this position. When
you select "ON," set "DOLBY
DIGITAL," "MPEG," and "DTS." For
details on setting these items, see
"Setting the digital output signal."
OFF
The player does not output the audio
signals via the DIGITAL OUT
(COAXIAL and OPTICAL) jacks. The
influence of the digital circuit upon the
analog circuit is minimal.
62
Setting the digital output signal
Switches the method of outputting audio
signals when you connect the following
component using a digital cord via the
DIGITAL OUT (COAXIAL and OPTICAL)
.
jacks
— Amplifier (receiver) with digital input
jack
— Amplifier (receiver) with a built-in DTS,
MPEG audio, or DOLBY DIGITAL
decoder
— MD or DAT deck
For connection details, see page 19.
Select "DOLBY DIGITAL," "MPEG," and
"DTS" after setting "DIGITAL OUT" to
"ON."
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DOLBY SURROUND
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
xDOLBY DIGITAL
Selects the Dolby Digital signals output via
the DIGITAL OUT (COAXIAL and
OPTICAL) .
jacks
D-PCM
Select this when the player is
connected to an audio component
lacking a built-in Dolby Digital
decoder. You can select whether the
signals conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the "DOWNMIX"
item in "AUDIO SETUP" (page 61).
DOLBY
Select this when the player is
DIGITAL
connected to an audio component
with a built-in Dolby Digital
decoder.
If the player is connected to an audio
component lacking a built-in Dolby
Digital decoder, do not set this.
Otherwise, when you play the Dolby
Digital sound track, a loud noise (or
no sound) will come out from the
speakers, affecting your ears or
causing the speakers to be damaged.
OFF
STANDARD
ON
D-PCM
PCM
OFF