Operation - MULTIQUIP STOW CMS-64S Operation And Parts Manual

Operation

1. To position the tub, make sure the mixer is placed on firm level
ground, then pull up on the dump latch (Figure 19) and turn
the hand wheel until the tub is at the desired position. Once
the tub is at the desired position, pull down on the dump latch
to lock the tub in position.
Figure 19. Mixing Drum Positioning
CAUTION: CAUTION:
CAUTION: CAUTION: CAUTION:
NEVER stand in front or behind the mixing
drum while it is being placed in the dump
position. Stay clear of the mixing drum while
it is being positioned.
2. As the drum rotates, use a shovel (Figure 20) to place the
cement mix inside the drum, add water as required. Be careful
to only place the tip of the shovel inside the drum.
Figure 20. Filling Mixing Drum
STOW CMS-64S CONCRETE MIXER — OPERATION & PARTS MANUAL — REV. #3 (08/04/06) — PAGE 23
STOW CMS-64S CONCRETE MIXER — OPERATION
3. Placing the shovel all the way inside the drum (Figure 21) will
Stopping the Mixer (Gasoline)
1.
2.
3.
2.
3.
cause the shovel to strike the blades. This condition will make
the shovel rotate, and could cause injury to personnel.
NEVER place hands inside the mixing drum while it is
rotating.
Figure 21. Filling Mixing Drum
Push the main start/stop switch (Figure 22) inward to stop
the engine.
Figure 22. Start/Stop Button (Stop Position)
Place fuel shut-off lever in the OFF position.
Clean drum of all debris and foreign matter.
Stopping the Mixer (Electric)
1. Place the electric motor's ON/OFF switch (Figure 23) in
the OFF position.
Figure 23. Electric Motor ON/OFF Switch
Disconnect the electric motor's extension cord from its
power source.
Clean drum of all debris and foreign matter.
(OFF Position)