Specifications - Sony HT-DDWG700 Operating Instructions Manual

If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy
the problem (page 23). However, note that all
memorized settings will be reset to their initial
settings and you will have to readjust all
settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields
62
GB

Specifications

Amplifier section
Models of area code CEL, CEK AU
Power Output
Stereo mode (rated) (6 ohms 1 kHz, THD 1%)
Surround mode
(6 ohms 1 kHz, THD 10%)
See
Surround mode
(6 ohms 100 Hz, THD 10%)
page 23
page 44
1)
Area code
CEL, CEK, AU
2)
Inputs
Tone
Reproduction frequency range:
FM tuner section
Tuning range
Antenna
Antenna terminals
Intermediate frequency
1)
85 W + 85 W
2)
(reference)
RMS output
FRONT:133 W
per channel
CENTER: 133 W
SURROUND: 133 W
per channel
2)
(reference)
SUB WOOFER: 135 W
Measured under the following conditions:
Power requirements
230 V AC, 50 Hz
Reference power output for front, center, surround
speakers and sub woofer. Depending on the sound
field settings and the source, there may be no
sound output.
Analog Sensitivity: 800 mV/
50 kohms
Digital (Coaxial) Impedance: 75 ohms
Gain levels ±6 dB, 1 dB step
28 – 20,000 Hz
87.5 - 108.0 MHz
FM wire antenna
75 ohms, unbalanced
10.7 MHz