Flying Sxhf218 - Martin Audio SX Series User Manual

SXHF218

Flying SXHF218

WPLGRIDt
Using one or two motors position a WPLGRIDt above the
SCXF118 and lower it onto the enclosure.
Replace the WPLGRIDt pins to link the SXHF218 securely to
the WPLGRIDt. The SXHF218 pins for the first cabinet are not
needed in this configuration and can be placed back in the
stowed position.
Remove the pins from the stow position, rotate the links to line
up with the pin hole position on the SXHF218 above.
Copyright © 2020 Martin Audio Ltd.
Remove the 4 link pins from the WPLGRIDt and also remove
the 4 pins from the from SXHF218 to release the links. Rotate
the SXHF218 links and line them up with the pin holes in the
WPLGRIDt.
Raise the WPLGRIDt and SXHF218 to a height suitable to fit
another SXHF218 below the array, lower it making sure the
protective nylon skids line up and fit into the recessed channels
on the SXHF218 below.
Replace the pins into the lock position on the cabinet above
making sure all four links are securely attached. Repeat the
process until the correct amount of SXHF218's are flown, the
maximum number is 16 SXHF218.
72
SX SERIES USER GUIDE
SX SERIES USER GUIDE V2.2