Sony VPL-CX70 Operating Instructions Manual page 16

Notes
• The projection size that can be
adjusted with the automatic focus
adjustment is from 40-inch up to 150-
inch. However, it may not be perfectly
adjusted depending on the brightness
of the room, the state of the screen, or
the use of the Side Shot. In this case,
adjust it manually in step 8 on
page 17.
• When the projector is turned on, the
Startup screen is projected (VPL-
CX76 only).
For details, see the attached "Operating
Instructions for "Memory Stick"" stored
on the CD-ROM.
3
Turn on the equipment connected to
the projector.
4
Press the INPUT key to select the
input source.
Each time you press the key, the input
signal switches as follows:
Input-A t Input-B t Video t S-Video
(VPL-CX76
only)
To input from
Computer connected to
the INPUT A connector
Air Shot/"Memory
Stick" (when you use the
Air Shot/"Memory
Stick") (VPL-CX76
only)
Video equipment
connected to the VIDEO
input connector
Video equipment
connected to the
S VIDEO input
connector
Smart APA (Auto Pixel Alignment)
adjusts the picture of the connected
equipment so that it is projected clearly.
16
Projecting
5
Press INPUT
to display
Input-A
Input-B
Video
S-Video
6
Notes
• For Input-B, input from the "Air Shot" or
"Memory Stick" can be switched by
selecting with the Input-B Select menu,
or pressing the
AIR SHOT key on the Remote
Commander. The Air Shot Home or the
Memory Stick Home is displayed on the
screen (VPL-CX76 only).
• If "Auto Input Search" is set to "On," the
projector searches for the signals from
the connected equipment and displays
the input channel where the input signals
are found.
For details, see "Auto Input Search"
on page 29.
• The Smart APA feature is effective for
the input signal from a computer only.
Switch the equipment connected to
output to the projector.
Depending on the type of your
computer, for example a notebook, or an
all-in-one LCD type, you may have to
switch the computer to output to the
projector by pressing certain keys (e.g.,
, etc.), or by changing
/ /
,
LCD
VGA
your computer's settings.
F7
Fx
or
and
Fn
Note
The key used for switching the computer to
output to the projector varies depending on
the type of computer.
Adjust the upper or lower position of
the picture.
To adjust using the Remote
Commander
Press the TILT/KEYSTONE key on the
Remote Commander to display the Tilt
key or the