Other - Sony VPL-CS6 Operating Instructions Manual

B

Other

On the emergency
mode
Before performing the following procedure,
try to diagnose the problem using the
instructions described in "Troubleshooting"
(page 44). If the problem persists, read and
following procedure thoroughly and then
proceed.
The projector is equipped with the
emergency mode for the lens protector and
the powered tilt adjuster. If the powered
function does not work, you can operate the
lens protector and the tilt adjuster
(emergency mode) manually.
Note
Perform this procedure only in an
emergency case. You cannot recover the
powered function yourself if you perform
this procedure. After you use the projector in
the emergency mode, consult with qualified
Sony personnel immediately.
To switch to the emergency mode,
follow the steps below.
1
Place a protective sheet (cloth)
beneath the projector. Turn the
projector over so you can see its
underside.
Adjuster
48
GB
On the emergency mode
2
Slide switch A in the slit in front of the
adjuster in the direction of the arrow
(toward the front panel of the projector)
with the small minus screwdriver.
The lens protector and the tilt adjuster
are switched to the emergency mode
3
When opening/closing the lens
protector, turn the groove of the
adjuster with a coin.
When the lens protector is left open, or
the tilt adjuster is extended, turn the
groove counterclockwise (in direction of
the arrow).
.
Slit