Advertisement
1. Use the anti-static wrist strap to discharge the static electricity
form your body.
5.1.3. Handling of optical pickup
1. To keep the good quality of the optical pickup maintenance parts
during transportation and before installation, the both ends of the
laser diode are short-circuited. After replacing the parts with new
ones, remove the short circuit according to the correct procedure.
(See this Technical Guide.)
2. Do not use a tester to check the laser diode for the optical pickup.
Failure to do so will damage the laser diode due to the power
supply in the tester.
5.2. Handling Precautions for Traverse Unit (Optical Pickup)
1. Do not give a considerable shock to the traverse unit (optical
pickup) as it has an extremely high-precise structure.
2. When replacing the optical pickup, install the flexible cable and
cut its short land with a nipper. See the optical pickup
replacement procedure in this Technical Guide. Before replacing
the traverse unit, remove the short pin for preventing static
electricity and install a new unit. Connect the connector as short
times as possible.
3. The flexible cable may be cut off if an excessive force is applied to
it. Use caution when handling the cable.
4. The half-fixed resistor for laser power adjustment cannot be
adjusted. Do not turn the resistor.
6. DISASSEMBLING THE CASING AND CHECKING
P.C.B.S
6.1. Disassembly Procedure
PDF created with pdfFactory Pro trial version
8
www.pdffactory.com
Advertisement
