Panasonic PT-RZ21К Operating Instructions Manual page 123

3) Press the <ENTER> button.
f The [MEASURED MODE] screen is displayed.
4) Press as to select [MEASURED DATA].
f The adjustment condition can be reset by selecting [RESET]. For details regarding [RESET], refer to
"Resetting the adjustment condition of the color matching" (x page 123).
5) Press the <ENTER> button.
f The [MEASURED DATA] screen is displayed.
6) Measure the current luminance (Y) and the chromaticity coordinates (x, y) using the colorimeter.
7) Press as to select a color, and press qw to adjust the setting.
f Set [AUTO TESTPATTERN] to [ON] to display a test pattern of selected colors.
8) Once all the input is completed, press the <MENU> button.
f The [MEASURED MODE] screen is displayed.
f When [MEASURED] is selected in Step 2), proceed to Step 9) and enter the coordinates of desired colors.
9) Press as to select [TARGET DATA].
10) Press the <ENTER> button.
f The [TARGET DATA] screen is displayed.
11) Press as to select a color and press qw to input coordinates for desired colors.
f By setting [AUTO TESTPATTERN] to [ON], the test pattern for the selected color is displayed.
12) Once all the input is completed, press the <MENU> button.
Note
f Colors are not displayed properly when target data is a color outside the region of this projector.
f Set the [AUTO TESTPATTERN] to [ON] to automatically display a test pattern for use in adjusting the selected adjustment colors.
f [AUTO TESTPATTERN] settings change together with the [AUTO TESTPATTERN] of [EDGE BLENDING].
f Before using a colorimeter or similar instrument to measure measurement data, set [PICTURE MODE] to [DYNAMIC].
f A difference in the color coordinates of target data and measurement values obtained from an instrument may occur for certain instruments
and measurement environments used.
Resetting the adjustment condition of the color matching
Reset all the adjustment items of the color matching adjusted in [3COLORS], [7COLORS], and [MEASURED].
1) Press as to select [COLOR MATCHING].
2) Press qw to select [3COLORS], [7COLORS], or [MEASURED].
3) Press the <ENTER> button.
f The [3COLORS], [7COLORS], or [MEASURED MODE] screen is displayed.
4) Press as to select [RESET].
5) Press the <ENTER> button.
f The confirmation screen is displayed.
6) Press asqw to select [RESET].
7) Press qw to switch the item.
f The items will switch each time you press the button.
[PICTURE MODE]
[NATIVE]
8) Press asqw to select [OK], and press the <ENTER> button.
f The value for color matching is overwritten.
Chapter 4 Settings — [DISPLAY OPTION] menu
Sets all the adjustment items of the color matching to the color value of the factory default for the
currently selected picture mode.
Set the picture mode in the [PICTURE] menu → [PICTURE MODE].
Sets all the adjustment items for color matching to uncorrected value.
ENGLISH - 123