Required Tools: • #2 Phillips Screwdriver • 5mm Allen Key Please note that while the instructions below show a treadmill, they are valid for all 4-series equipment. Use a #2 phillips screwdriver to remove the six (6) #8-18 x 3/4” screws securing the front of the console to the back shroud, then remove the front of the console.
Page 3
Slide the PVS bracket-compatible upper cover over the PVS bracket and secure to the rear console shroud using the #8-18 x 3/4” screws removed in Step 2. Slide the PVS bracket grommet over the PVS bracket - be careful of orientation. Use a #2 phillips screwdriver to remove the eight (8) #8-18 x 3/4”...
Page 4
Use a #2 phillips screwdriver to remove the four (4) M4 x 8mm pan head machine screws from the back of the PVS, then use these screws to secure the PVS to the PVS bracket. 1: PVS 2: To PVS 3: PVS Audio 4: Coax Power...
Page 5
Use a #2 phillips screwdriver to remove the screw securing the blank entertainment insert to the console front, then install the PVS controller into the console front and securing using the same screw. Disconnect the cables from the back of the USB Panel Assembly, use a #2 phillips screwdriver to remove the two (2) #8-18 x 3/4”...
Page 6
Connect the other end of the PVS controller cable into the PVS controller. Connect the other end of the 3.5mm audio cable to the audio PCB on the USB Panel Assembly To Back/Bottom of PVS installed in Step 12. Reconnect the cables from the unit neck to the console, then secure the console front to the console rear shroud using the #8-18 x 3/4”...