Table of Contents
Advertisement
10.1.1. Saving the radio remote control
The radio remote control supplied is the WI-CONTROL model, with 30 channels and a
display, which transmits at the radio frequency of 433.92 MHz; no other radio remote
control model is provided for the CLOUD RADIO. Several actuators can be controlled with
a single radio remote control, however each channel must correspond to a CLOUD RADIO
actuator and thus a window.
The encoding used varies for each channel, so each transmission will send a signal that is
different from all the others. It follows that the receiver must be able to recognize the
enabled transmitters, thus the transmission codes should be saved following the procedure
below:
Equip yourself with the radio remote control, checking beforehand that it is working,
has charged batteries and is in good condition.
Select the desired channel on the radio remote control. (Consult the instructions
manual of the WI-CONTROL radio remote control).
On the CLOUD RADIO, briefly press (for about 1 second) the small "
located near the terminal block. The slowly flashing LED indicates that it is waiting to
receive a valid radio code.
Within 10 seconds, press any one of the up arrow ▲,
two times (once to activate the display of the radio remote control and the second
time to transmit the radio code).
If the code is saved correctly, the LED will emit one long flash (1 sec.) to confirm;
then the LED will go out and remain at rest.
If the code is not saved correctly - due to the memory being full, for example, or the
radio remote control being incompatible - the LED will emit a series of quick flashes
for about 1 second; then the LED will go out and remain at rest.
10.1.2. Erasing the radio memory
To completely erase the memory of the radio remote control on the machine, press the
"
" button and hold it pressed for about 20 seconds until the LED begins to flash quickly.
PRG
At this point you can release the button; the flashing continues until the memory has been
completely erased.
10.1.3. Remotely saving a radio remote control
A new radio remote control can be saved remotely – i.e., without accessing the
– only if at least one radio remote control has already been saved as described in point
10.1.1 and you have the radio remote control which is already recognized. To remotely
save a radio remote control, follow the procedure below:
Equip yourself with the WI-CONTROL radio remote control to be saved and set it on
the desired channel (see the instructions provided with the radio remote control).
Equip yourself with the radio remote control already saved and operating on the
CLOUD RADIO in question.
On the already saved radio remote control, press the following buttons in sequence:
F1, F2 and then
the same way as pressing the PRG button).
Page 10
. This sequence "opens" the memory of the CLOUD RADIO (in
STOP
or down arrow ▼ buttons
STOP
" button
PRG
button
PRG
Advertisement
Table of Contents
