Battery Management Studio; Registers Screen; Figure 3-1. Registers Screen - Texas Instruments bq34z100EVM User Manual

www.ti.com

3 Battery Management Studio

3.1 Registers Screen

Apply power to the EVM after you have completed the EVM Connections section. Run Battery Management
Studio from the Start | Programs | Texas Instruments | Battery Management Studio menu sequence, or the
Battery Management Studio shortcut. The Registers screen (see
contains parameters used to monitor gauging. The Bit Registers section provides a bit-level picture of status and
fault registers. A green flag indicates that the bit is 0 (low state) and a red flag indicates that the bit is 1 (high
state). Data begins to appear once the Refresh (single-time scan) button is selected, or it scans continuously, if
the Scan button is selected.
The continuous scanning period can be set via the | Window | Preferences | SBS | Scan Interval | menu
selection.
The Battery Management Studio program provides a logging function which logs the values selected by the Log
check boxes located beside each parameter in the Registers section. To enable this function, select the Log
button; this causes the Scan button to be selected. When logging is stopped, the Scan button is still selected and
has to be manually deselected.
SLUU904B – APRIL 2012 – REVISED APRIL 2021
Submit Document Feedback

Figure 3-1. Registers Screen

bq34z100EVM Wide Range Impedance Track™ Enabled Battery Fuel Gauge
Copyright © 2021 Texas Instruments Incorporated
Figure 3-1) appears. The Registers section
Battery Management Studio
7
Solution