Connecting The Camera To A Router Not Supporting Upnp™ (Ipv4 Only) - Panasonic KX-HCM110A Operating Instructions Manual

Operating Instructions
2.7.2 Connecting the Camera to a Router Not Supporting
UPnP™ (IPv4 Only)
To allow access from the Internet with a router not supporting UPnP
procedures below.
1.
Select [Static] on the Network (IPv4) page.
(1) Access the camera (see page 13).
(2) Click [Setup] tab at the top of the page.
(3) Select [Static] on the Network page.
•
(4) Click [Save] without changing the settings.
(5) Click [Restart].
2.
Enable port forwarding on the router.
Using the IP address and port number note written on step 1-(3), enable port
forwarding on the router. See the router manual for how to enable port
forwarding.
3.
Register with the DynamicDNS service.
Port Forwarding feature
The port forwarding feature is required to allow access from the Internet with a
router not supporting UPnP
Each camera must be assigned a unique port number.
Global IP address
of the router
vvv.xxx.yyy.zzz:80
vvv.xxx.yyy.zzz:81
Internet
Note
The IP addresses shown above may differ from those offered on your home network.
"Port forwarding" may be called "Address translation", "Static IP Masquerade", "Virtual server"
*1
or "Port mapping" in other products.
64
The Static IP Address Configuration page is displayed. Make a
note of the IP address and port number, since they are required to
enable port forwarding on the router.
Port No.
Modem
CATV
xDSL
Optical cable
Local IP address
(IPv4 Only)
*1
. It exchanges a local IP address to a global one.
TM
Port Forwarding feature
vvv.xxx.yyy.zzz:80
vvv.xxx.yyy.zzz:81
Router
192.168.0.1
192.168.0.253:80
192.168.0.252:81
192.168.0.252 192.168.0.253
Port No. 80
Port No. 81
, follow the
TM