Beko DU7112GAW User Manual page 13

Babyprotect
Jeans
Gentle Care / Shirts
Express Super Short
Energy consumption values
Programmes
Cottons cupboard dry*
Cottons Iron dry
Synthetics cupboard dry
* : Energy Label standard program (EN 61121:2012) All values in the table are determined
according to EN 61121:2012 standard. Consumption values may vary from the values in the chart
depending on laundry type, wringing speed, ambient conditions and voltage levels.
5.5 Auxiliary functions
Buzzer / time
Drying machine makes an audible warning
when the program is completed. If you don't
want the machine to make an audible warning,
press the "Buzzer / Time" button. When you
press the Buzzer/Time button, a light will
illuminate and no audible warning will be made
when the program ends.
C
NOTE
• You can select this function before or
after the program starts.
Buzzer/Time button is used to adjust program
duration while the Rack/Time programs are
selected.
Drying Level
Drying Level button is used for adjusting to
desired dryness level. Program duration may
change depending on the selection.
C
NOTE
• You can activate this function only prior
to start of program.
Dryer / User Manual
Program used for baby clothing with can
be dried approval on the label.
You may dry denim pants, skirts, shirts or
jackets in this programme.
It dries the shirts in a more sensitive
manner, and causes less creasing and
easier ironing.
Use this program to have 2 shirts ready for
ironing.
Capacity (kg)
7
7
3,5
3
4
1,5
0,5
Spin speed
in washing
machine
(rpm)
1000
1000
800
End time
You can delay the end time of the program up
to 24 hours with End time function.
1. Open the loading door and place the
laundry.
2. Select the drying program.
3. Press the End Time selection button and
set the delay time you wish. End Time
LED will illuminate. (When pressed and
hold the button, End Time proceeds non-
stop).
4. Press the Start / Stand-by button. End
Time countdown starts. ":" Separator in
the middle of displayed delay time flashes.
C
NOTE
• You can add or remove laundry within
end time. Displayed time is the sum of
normal drying time and end time. End
Time LED will turn off at the end of
countdown, drying starts and drying LED
will illuminate.
Changing the end time
If you want to change the duration during the
countdown:
Cancel the program by turning the On/Off/
Program selection knob. Select the program
you want and repeat the End Time selection
1200 80
1200 80
1200 40
1200 14
Approximate
Energy
amount of
consumption
remaining
value kWh
humidity
60% 3,92
60% 3,25
40% 1,42
13