Sony DR-CX530E Service Manual page 10

(5) Remove the three screws and remove the Motor B.
Screws
Motor B
P
T O
(6) Disconnect the connector and remove the FP-2189 Flexible
Board and the Radiation Sheet while detaching the four bosses.
T O
P
CM Radiation Sheet
FP-2189
Flexible Board
Bosses
Adhesive
Connector
part
FP-2189 Flexible Board
Bosses
Adhesive
part
T O
Connector
P
HDR-CX530E/CX535/CX610E/PJ530E/PJ540/PJ540E/PJ610E_L2
(7) Remove the six screws and remove the Frame (E-SUB-A), Frame
(E-SUB-B), Ball Bearing while detaching the six bosses and the
shaft.
Bosses
P
T O
Frame (E-SUB-A),
Ball Bearing
Shaft
Bosses
Hole Screws
Frame (E-SUB-B)
Screws
(8) Peel off the Adhesive Part of the Motor A Flexible Board while
detaching the two bosses.
Adhesive part
P
T O
Bosses
Flexible Board of
the Motor A
(9) Remove the three screws and remove the Sheet Metal B and the
Mecha Stop Rubber while detaching the two bosses.
P
T O
Sheet Metal B
Boss
Boss
Mecha Stop Rubber
Screw
(10) Remove the three screws and remove the Motor A while detach-
ing the two bosses.
Boss
T O
P
Motor A
Boss
Screws
1-6
(11) Remove the three screws and remove the Sheet Metal A while
detaching the six bosses, and then disconnect the lens Flexible
Board from the connector on the FP-2126 Flexible Board.
Lens
Flexible Board
Boss
Screws
Bosses
P
T O
Sheet Metal A
Screw
FP-2126 Flexible Board
(12) Peel off the Adhesive Part of the FP-2126 Flexible Board while
detaching the two bosses.
P
T O
Adhesive part
FP-2126 Flexible Board
– ENGLISH –
FP-2126
Flexible Board
Boss
Screw
Bosses
Lens
Connector Flexible
Board
Sheet Metal A
Bosses