Panasonic SDR-S100 Operating Instructions Manual page 15

∫ About the SD Memory Cards that you can use
Recording mode
Motion picture
recording mode
Still picture
recording mode
¢ The recording may suddenly stop during motion picture recording. (P35)
∫ About the SD card
≥ Do not touch the terminals on the back of the SD card.
≥ Electrical noise, static electricity, or failure of this unit or the SD card may damage or
erase the data stored on the SD card. We recommend saving important data on a
PC by using the USB cable (supplied) or MotionSD STUDIO. (P73) (When saving
images recorded using this unit to a PC, you must use MotionSD STUDIO. )
≥ When using an SD card on which data has been written many times, the remaining
time left for recording may be reduced. (P35)
∫ About the card access lamp
≥ When this unit accesses the SD card (reading, recording, playback, erasing, etc.),
the access lamp lights up.
≥ If the following operations are performed when the access lamp is lit, then the SD
card or the recorded data may be damaged or this unit may malfunction.
– Opening the card slot cover and inserting or removing the SD card.
– Operating the [ON/OFF] switch or the mode dial.
∫ About the write protection switch on the SD Memory Card
≥ The SD Memory Card has a write protection switch 1 on it. If the
switch is moved to [LOCK], you cannot write to the SD card,
delete the data on it or format it. If it is moved back, you can.
32 MB, 64 MB,
8 MB, 16 MB
Cannot be
Cannot be
guaranteed in
used.
operation
SD card capacity
128 MB
¢
Can be used.
256 MB, 512 MB, 1 GB,
(Maximum)
2 GB
Refer to page 34.
1
2
15
VQT0T50