Panasonic SDR-S100 Operating Instructions Manual page 101

Problem
The scenes are not
correctly displayed in
thumbnails.
"PUSH THE RESET
SWITCH." is displayed.
Even if connected by the
USB cable, this unit is
not recognized by the
PC.
When the USB cable is
disconnected, an error
message will appear on PC.
The warning/alarm
indication [°] appears
when this unit is
operated in the WEB
camera mode.
The [ ] indication
PictBridge
flashes when this unit is
connected to a PC.
The [ ] indication
WEB
appears when the unit is
connected to the printer.
≥ Scenes displayed as
thumbnails in shades of blue
and white cannot be played
back or deleted. If the scenes
are unnecessary, format the
SD card to erase the data.
≥ Please be aware that if an SD
card is formatted, then all the data recorded on the card
will be erased. Store important data on a PC, etc. When
saving scenes recorded using this unit to a PC, you
must use MotionSD STUDIO. (P73)
≥ The unit has automatically
detected an error. To protect the
data, remove the SD card and then
press the [RESET] button with the
projecting part 1 of the hand
strap. This will restart the unit.
When you press the [RESET]
button, the date and time setting
will also be reset. Set the date and
time again.
≥ Even after you press the [RESET] button, the indication
may still appear repeatedly. If so, this unit needs repair.
Detach the power connected, and consult the dealer
who you purchased this unit from. Do not attempt to
repair the appliance by yourself.
≥ Have you installed the Web camera driver?
> Install the driver, then check the connections.
≥ Have you set this unit to the correct mode?
> The unit is not recognized if it is set to motion picture
playback mode. (P80)
≥ Select another USB terminal on the PC.
≥ Check the operating environment. (P75, 76)
≥ Turn on the power to this unit.
≥
To disconnect the USB cable safely, double-click the
icon in the task tray and follow the instructions
on the screen.
≥ Did you press the record button or any other button?
> You cannot record onto the card in the WEB camera mode.
≥ Have you installed the Web camera driver?
> Install the driver, then check the connections.
≥ The unit is connected to a Windows XP PC in still
picture playback mode.
> Connect with a printer supporting PictBridge.
≥ The unit is connected to the printer in motion picture
recording mode or still picture recording mode.
> Change the mode to still picture playback mode.
Check points
SETUP
1/3 1/3
PLAY
1
VQT0T50
101