Audio Information; Troubleshooting - Panasonic SC-HTB500 Operating Instructions Manual

Audio information

∫ Compatible audio formats
This unit is compatible with the following formats:
Dolby Digital, DTS Digital Surround, 2-channel
LPCM and multi-channel LPCM.
≥ When using the optical digital audio cable, this
system is not able to play audio with a sampling
frequency greater than 48 kHz.
(Sound Effect and Dolby Virtual Speaker will be
automatically canceled if the audio signal's
sampling frequency is greater than 48 kHz.)

Troubleshooting

Before requesting service, make the following
checks. If you are in doubt about some of the check
points, or if the solutions indicated in the following
guide do not solve the problem, refer to "Customer
Services Directory (United States and Puerto Rico)"
on page 22 if you reside in the U.S.A. or Puerto
Rico, or refer to "Product information" on page 22 if
you reside in Canada.
General operation
To return to the factory preset.
≥ While this unit is on, press [POWER Í/I] on this
unit for more than 4 sec.
(All the indicators will blink twice when the unit is
reset.)
The remote control doesn't work properly.
≥ It is possible that the insulation sheet has not
been removed. Remove the insulation sheet.
( 7)
≥ The remote control and this unit are using
different codes. Change the code on the remote
control. ( 20)
≥ It may be necessary to set the code of the remote
control again after changing the battery of the
remote control. (
This unit does not operate correctly.
≥ If the HDMI cable is connected to the wrong
terminal (HDMI AV IN or HDMI AV OUT), this unit
will not operate correctly. Turn this unit off,
disconnect the AC power supply cord and
reconnect the HDMI cable(s). (
18
20)
11)
When operating the connected device, this unit
reacts in an unwanted manner.
≥ HDAVI Control commands may use a different
signal depending on the make of the device. In
this case, set "VIERA Link" to "Off". (
"VIERA Link")
VIERA Link related operations no longer
function properly.
≥ Check the "VIERA Link" setting on the connected
devices.
≥ When the HDMI connections are changed, after a
power failure or after the AC power supply cord
has been removed, VIERA Link operations may
not function properly.
Power
No power.
≥ Insert the AC power supply cord securely. (
≥ After turning this unit on, if the "TV, BD/DVD"
indicator or the " D/DTS" indicator blinks and
this unit immediately turns off, unplug the AC
power supply cord and consult your dealer.
The unit is automatically switched to standby
mode.
≥ This unit will automatically turn to standby mode
after 30 min if it is inactive. (
Power of this unit is turned off when the input
for the TV is changed.
≥ This is a normal feature when using VIERA Link
(HDAVI Control 4 or later). For details please
read the operating instructions for the TV.
20,
13)
13)