Connecting An Amplifier Or System Component - Panasonic DMR-E65S Operating Instructions Manual

Connecting an amplifier or system component

∫ Connection to a stereo amplifier
If the antenna connector doesn't match
Other antenna connections to the unit
Use one of the following connections to suit the antenna lead.
≥If your television has both lead and coaxial VHF terminals, use
the lead connection to minimize signal loss.
∫ A single twin lead
from the antenna
(Flat) Twin lead
300 ≠ cable
∫ A twin lead and a coaxial cable
from the antenna
(Flat) Twin lead 300 ≠ cable
(Round)
75 ≠ coaxial cable
∫ Two twin leads
from the antenna
(Flat) Twin lead
300 ≠ cable
300–75 ≠ transformer
Amplifier's rear panel
AUDIO IN
R L
Red White
Audio cable
Optical digital audio
cable
Do not bend sharply
To OUT1 or OUT2
when connecting.
Red White
G-LINK R - AUDIO - L VIDEO S-VIDEO
R - AUDIO - L VIDEO S-VIDEO
300–75 ≠ transformer
To this unit's RF IN
terminal
VHF/UHF band mixer
To this unit's RF IN
terminal
VHF/UHF band mixer
To this unit's RF
IN terminal
∫ To enjoy multi-channel surround sound on
DVD-Video
Connect an amplifier with a built-in decoder
displaying these logo marks using an optical digital
audio cable and change the settings in "Digital Audio
Output" (➡ page 44).
≥You cannot use DTS Digital Surround decoders not suited to
DVD.
≥Even if using this connection, output will be only 2 channels when
playing DVD-Audio.
Amplifier's rear panel
OPTICAL IN
R - AUDIO - L VIDEO S-VIDEO (L1)
Y P P
B R
OPTICAL
COMPONENT
VIDEO OUT
DIGITAL AUDIO OUT
(480P/480I) R - AUDIO - L VIDEO S-VIDEO
(L3)
(PCM/BITSTREAM)
Other antenna connections from the unit to the
television
Use one of the following connections to suit the antenna terminals
on your television. Refer to the television's operating instructions.
∫ A twin lead and coaxial plug terminal
VHF/UHF band separator
75 ≠ coaxial cable
∫ A twin lead terminal
75–300 ≠ transformer
75 ≠ coaxial cable
∫ Two twin lead terminals
VHF/UHF band separator
75 ≠ coaxial cable
∫ Multiple antenna terminals
≥Connect to one of the ANT terminals, then change the television's
settings as necessary.
Split out
ANT 1
75 ≠ coaxial cable
Insert fully, with this
side facing up.
This unit
RF IN
RF OUT
VHF/UHF
VHF
UHF
Television
VHF or
UHF
Television
VHF
UHF
Television
Television
ANT 2
RQT7303
9