Installation - Furuno FI-3005 Operator's Manual

2

Installation

The installation includes 6 major steps:
1. Read the operation manual.
2. Plan where to install the transducers, Server and instruments.
3. Install the transducers, then the Server and instruments.
4. Run the cables.
5. Take a break and admire your installation.
6. Learn the functions and calibrate your system.
Before you begin drilling ... think about how you can make the installation as neat
and simple as your boat will allow. Plan where to position the transducers, Server
and instruments. Think about leaving space for additional instruments in the future.
A few "do nots" you should consider:
Do not cut the cables too short. Allow extra cable length at the
Server so it can be disconnected for inspection without having to
disconnect all attached cables.
Do not place sealant behind the display. The instrument gasket
eliminates the need for sealant.
Do not run cables in the bilge, where water can appear.
Do not run cables close to fluorescent light sources, engine or radio
transmitting equipment to avoid electrical disturbances.
Do not rush, take your time. A neat installation is easy to do.
The following material is needed:
Wire cutters and strippers
Small and large philips and small flat head screw driver
Hole saw for the instrument clearance hole 63 mm (2½ ")
2.8 mm (0.11") drill for the mounting holes
Plastic cable ties
If the cable is not long enough, you can buy the optional 8 m (26 ft) extension
cable. The same 4-pole FI-30 cable is used for all connections.
If you are doubtful about the installation, obtain the services of an experienced
technician.
8