Installation - First Alert DWH-47 User Manual

INSTALLING CAMERAS
1. Select the position for the camera and secure the camera stand.
(Screws and anchors are supplied. Use an appropriate screw type
for the mounting surface.)
2. Screw the camera onto the bracket.
SETTING UP THE WIRELESS RECEIVER
1. Flip out the stand, extend the antenna, connect AC/DC adapter to the input on the side of the monitor.
2. Press and hold the POWER button on the top of the monitor for 3 - 4 seconds to power it up.
3. The receiver displays Welcome Screen for a few seconds and then transitions to the LIVE view.
4. Place the SD card into the SD card slot located on the side of the monitor
5. Once the receiver is connected, see Camera Setup, Pairing (Operating Menus) to link the camera(s) to
the receiver.
Note: The screen remains dark until the cameras are powered up. The monitor is fitted with a
rechargeable battery and can operate for up to 2 hours on battery power once fully charged (w/Power
Saving function activated). The monitor can be carried around anywhere within operating range of the
camera(s), but should be used in a dry environment as it is not weatherproof. Operating range is up to
approximately 500 feet (152 meters) line of sight. Typical range is 150' - 200' (46 - 61 meters) through
normal household obstructions. Increased metal objects such as aluminum siding, metal beams,
pipes, metal racking may reduce range.
Battery Used In the LCD Monitor
The LCD monitor is fitted with a 3.7V 1800mAH (Li-ON) rechargeable battery pack. If the power supply
adaptor is kept connected to the monitor then the battery will begin recharging until fully charged. The
monitor can still be used if left connected to the power supply adaptor even the battery is fully charged.
Note:
1. From zero charge, the rechargeable battery takes approximately 8 hours to reach full charge.
2. The rechargeable battery will maintain 80% of its efficiency within the 300 charge-discharge cycle.
3. The rechargeable battery is not user replaceable. Do not try to change the battery or remove the battery.
CAMERAS & WIRELESS RECEIVER
3. Adjust camera to the proper view angle Make
sure the lens is upright relative to your subject.
Tighten the thumb bolt.
4. Screw the antenna into place on the rear of
the camera. Adjust the antenna to an upright
position.
5. Connect the power cable to the DC IN of the
camera.
6. Plug the power supply into the electrical outlet.
7. Once the camera is connected, see Camera
Setup, Camera Pairing to link the camera(s) to
the receiver.
Camera Orientation
It's important the camera is mounted correctly
to ensure the image is not upside down as the
camera lens can only be positioned one way.

INSTALLATION

Page 9
4