Advertisement
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Open the chuck by turning the sleeve (5) counterclock-
u
wise.
Insert the bit shaft (6) into the chuck.
u
Insert the chuck key (7) into each hole (8) in the side of
u
the chuck and turn clockwise until tight.
Open the chuck as far as possible.
u
Remove the chuck retaining screw, located in the chuck,
u
by turning it clockwise using a screwdriver.
Tighten an Allen key into the chuck and strike it with a
u
hammer as shown.
Remove the Allen key.
u
Remove the chuck by turning it counterclockwise.
u
u
with the chuck retaining screw.
Use
Warning! Let the tool work at its own pace. Do not overload.
Warning!
for the location of wiring and pipes.
For drilling and for tightening screws, use forward (clock-
wise) rotation. For loosening screws or removing a jammed
drill bit, use reverse (counterclockwise) rotation.
To select forward rotation, push the forward/reverse
u
slider (3) to the left position.
To select reverse rotation, push the forward/reverse
u
slider to the right.
Viewed when holding the drill in the operating position.
After any reversing operations, return slider (3) to
forward position.
Warning! Never change the direction of rotation while the
motor is running.
Switching on and off
To switch the tool on, press the variable speed switch
u
(1). The tool speed depends on how far you press the
switch.
For continuous operation, press the lock-on button (2)
u
and release the variable speed switch. This option is
available only at full speed.
To switch the tool off, release the variable speed switch.
u
To switch the tool off when in continuous operation,
press the variable speed switch once more and release
it.
Based on the different applications, turn around the
u
speed dial (9) to control the maximum speed.
@
Warning! To reduce the risk of serious personal
injury, ALWAYS use proper hand position as
@
Warning! To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
DRILLING IN METAL
Start drilling with slow speed and increase to full power while
metal chips indicates the proper drilling rate. Use a cutting
lubricant when drilling metals. The exceptions are cast iron
and brass which should be drilled dry.
NOTE: Large [5/16" (8 mm) ] holes in steel can be made easier
if a pilot hole [5/32"(4 mm) ] is drilled first.
DRILLING IN WOOD
Start drilling with slow speed and increase to full power while
made with the same twist drills used for metal. These bits
may overheat unless pulled out frequently to clear chips from
with a block of wood.
Accessories
The performance of your tool depends on the accessory
used.Black & Decker accessories are engineered to high
quality standards and designed to enhance the performance
of your tool. By using these accessories you willget the very
best from your tool.
Maintenance
Your tool has been designed to operate over a long period of
time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
Warning! Before performing any maintenance, switch off
and unplug the tool.
Regularly clean the ventilation slots in your tool using a
u
soft brush or dry cloth.
EN GL IS H
5
Advertisement
