Table of Contents
Advertisement
The mains cable is only replaced by
■
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
■
extension cables are used.
If an earth-leakage circuit breaker is
■
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
■
all times.
The mains cable is not bent,
■
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without any laundry.
Notes
The washing machine must be
■
correctlyinstalled and connected.
(from ~ Page 40).
Never use a damaged machine.
■
Inform your customer services.
Preparatory work:
Check the machine.
1.
Fill the ß and i/ß dispensers.
2.
~ Page 25
Remove the protective film from the
3.
control panel.
Connect the mains plug.
4.
Turn the tap on.
5.
Run the programme without laundry.
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum clean 90 °C
3.
programme.
Positioning and connecting
Open the detergent drawer.
4.
Pour approx. 1 litre of water into
5.
compartment u v.
Pour standard detergent into
6.
compartment u v.
To prevent foaming, only use
Note:
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for woollens or delicates.
Close the detergent drawer.
7.
Press the A button.
8.
Switch off the appliance at the end of
9.
the programme.
Your washing machine is now ready to
use.
Transportation
E.g. when moving house
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers.
Leaking detergent/fabric softener can
prevent the appliance from working
correctly, e.g. due to damage to the
electronics.
Empty the dispensers before
transporting the appliance.
Preparatory work:
Turn off the tap.
1.
Reduce the water pressure in the
2.
supply hose: ~ Page 32; cleaning
and maintenance – filter in the water
supply clogged
Disconnect the washing machine
3.
from the mains.
Drain any residual water:
4.
~ Page 31; cleaning and
maintenance – drain pump blocked,
emergency draining
Remove the hoses.
5.
Empty the dispensers. ~ Page 30
6.
Installing the transport braces:
Remove the covers and keep them
1.
in a safe place.
en
45
Advertisement
Table of Contents
