JVC TH-A85 Service Manual page 23

3.4.8 Removing the power transformer
(See Fig.11)
• Prior to performing the following procedures, remove the am-
plifier assembly, rear panel, SP terminal board and mother
board assembly.
(1) Remove the tie band, and remove the four screws L attach-
ing the power transformer.
(2) Take out the power transformer from the amplifier assem-
bly.
3.4.9 Removing the speaker net
(See Figs.12 and 13)
(1) Insert the tip of a flat-bladed screwdriver or similar tool into
the space between the speaker main body and speaker
net, and lift the speaker net little by little to remove. (See
Figs.12 and 13)
Note:
To prevent damaging the speaker net and speaker main
body, insert cushioning plates etc. to the section f and
below the tip of the flat-bladed screwdriver or similar tool.
(2) Take out the speaker net from the speaker main body.
Tie band
AC bracket
L L
Fig.11
Section f
Speaker net
Fig.12
Section f
Chshioning
Speaker net blate,etc.
Speaker main body
Fig.13
L
Power
transformer
Speaker main body
Flat-bladed
screwdriver,etc.
(No.MB040)1-23