JVC TH-A85 Service Manual page 15

Hide thumbs Also See for TH-A85:

Table of Contents

3.3.6 Removing the motor

(See Fig.6)

• Prior to performing the following procedures, remove the

clamper base and tray drive board.

(1) From the top side of the DVD mechanism assembly, re-

move the belt of the pulley gear.

Note:

Take care not to attach grease on the belt.

(2) Remove the screw C attaching the motor to the DVD mech-

anism assembly.

3.3.7 Removing the DVD traverse mechanism assembly

(See Fig.7)

• Prior to performing the following procedures, remove the DVD

servo board and clamper base.

(1) From the top side of the DVD mechanism assembly, re-

move the four screws D attaching the DVD traverse mech-

anism assembly to the loading base.

(2) Take out the DVD traverse mechanism assembly from the

loading base.

Pulley gear

Belt

Fig.6

DVD traverse mechanism assembly

Fig.7

DVD mechanism assembly

Loading base

(No.MB040)1-15

Table of Contents