Advertisement
English
Fig. DD
Crown molding flat on table and against fence
PRETESTING WITH SCRAP MATERIAL IS EXTREMELY IMPORTANT!
Alternative Method for Cutting Crown Molding (Fig. EE)
Place the molding on the table at an angle between the fence and the saw table, as shown in
Figure EE. Use of the crown molding fence accessory (DW7084) is highly recommended because
of its degree of accuracy and convenience (Refer to Optional Accessories). The crown molding
fence accessory is available for purchase from your local dealer.
The advantage to cutting crown molding using this method is that no bevel cut is required.
Minute changes in the miter angle can be made without affecting the bevel angle. This way,
when corners other than 90º are encountered, the saw can be quickly and easily adjusted for
them. Use the crown molding fence accessory to maintain the angle at which the molding will
be on the wall.
Instructions for Cutting Crown Molding Angled Between the
Fence and Base of the Saw For All Cuts
1. Angle the molding so the bottom of the molding (part which goes against the wall when
installed) is against the fence and the top of the molding is resting on the saw table, as
shown in Figure EE.
2. The angled "flats" on the back of the molding must rest squarely on the fence and saw table.
INSIDE CORNER
Miter right at 45°
Left side
Save right side of cut
Miter left at 45°
Right side
Save left side of cut
Fig. EE
Fence
Crown Molding Between Fence and Table
Special Cuts
NEVER MAKE ANY CUT UNLESS THE MATERIAL IS SECURED ON THE TABLE AND AGAINST
THE FENCE.
Aluminum Cutting (Fig. FF, GG)
ALWAYS USE THE APPROPRIATE SAW BLADE MADE ESPECIALLY FOR CUTTING ALUMINUM. These
are available at your local D
WALT retailer or D
e
their size, shape or surface finish, may require the use of a clamp or fixture to prevent movement
during the cut. Position the material so that you will be cutting the thinnest cross section, as
shown in Figure FF. Figure GG illustrates the wrong way to cut these extrusions.
Use a stick wax cutting lubricant when cutting aluminum. Apply the stick wax cutting lubricant
directly to the saw blade before cutting. Never apply stick wax to a moving blade. The wax,
available at most hardware stores and industrial mill supply houses, provides proper lubrication
and keeps chips from adhering to the blade.
Be sure to properly secure workpiece.
Refer to saw Blades under Optional Accessories for correct saw blade.
14
Fence
Table
OUTSIDE CORNER
Miter left at 45°
Save right side of cut
Miter right at 45°
Save left side of cut
Bottom side
DW7084 Crown
of molding
Molding Fence
Top side
of molding
Table
WALT service center. Certain workpieces, due to
e
Fig. FF
Fence
Fig. GG
Fence
Bowed Material (Fig. HH, II)
When cutting bowed material always position it as shown in Figure HH and never like that
shown in Figure II. Positioning the material incorrectly will cause it to pinch the blade near the
completion of the cut.
Fig. HH
Fig. II
inCORRECT
Cutting Plastic Pipe or Other Round Material
Plastic pipe can be easily cut with your saw. It should be cut just like wood and ClAMPED OR
hElD FiRMlY TO ThE FEnCE TO KEEP iT FROM ROlling. This is extremely important when
making angle cuts.
Blade
CORRECT
Blade
inCORRECT
CORRECT
Advertisement
