Fujitsu Stylistic 3500 User Manual page 22

• Off state
All system functions are turned off to conserve power. The system does not
respond to the stylus or other input. The system boots at the next system
power-on.
Note: The system consumes the same amount of power whether it is in Save-to-Disk
mode or the Off state.
Your system may be configured to enter some of these states automatically after a
period of inactivity to conserve battery power.
When you use the Stylistic 3500 pen tablet, you can change the current system state
in a number of ways, depending on the current state of the system. To determine the
current system state, observe the Power icon in the Status display. Table 2-1 gives the
different system states represented by the Power icon and describes how you can
change the system state from the current state.
Power Icon
Appearance
Power icon displayed
continuously
Power icon blinking
Power icon not
displayed
* Information in Table 2-1 is supplied to help you understand which system states your system
can enter from the current system state. Refer to the procedures on starting the system,
shutting down the system, suspending system operation, and resuming system operation
given later in this chapter.
†
Your system may be configured to use either Suspend-to-RAM mode or Save-to-Disk mode.
16 Using the Stylistic 3500 Pen Tablet
Table 2-1 Changing System States
Current State
On State
or
Idle State
†
Suspend-to-RAM
Off State
or
†
Save-to-Disk
To Change State
To enter the Off state, shut down the system
using the Start menu on your system.
To enter Suspend-to-RAM or Save-to-Disk
state, suspend system operation using either
a hardware or software suspend.
To enter the On state, resume system
operation by pressing the Suspend/Resume
button.
To enter the Off state, resume system by
pressing the Suspend/Resume button, then
shut down your system.
To enter the On state, start your system, or
resume system operation by pressing the
Suspend/Resume button.
*
†