Calibrating The Touch Screen - Fujitsu Lifebook T1010 User Manual

Calibrating the Touch Screen

In order to ensure accurate tracking between the stylus and cursor, you must run the Touch Screen
Calibration Utility before you use the Touch Screen for the first time, or after you change the display
resolution.
To run the calibration utility:
1
Go to Start -> Control Panel. If you are not in Classic View, select "Switch to Classic View" in the left panel.
Double-click the Tablet PC Settings icon and select the General tab
2
Click the [Calibrate] button.
3
Adjust the display of your Tablet PC to a comfortable angle and find the (+) symbol in the upper-left corner of
the display.
D
O NOT USE EXCESSIVE FORCE WHEN TAPPING ON THE SCREEN DURING CALIBRATION
EXCESSIVE FORCE COULD RESULT IN DAMAGE TO THE
W
HEN USING THE STYLUS TO CALIBRATE THE SCREEN
WITH YOUR FINGERS
4
Using the stylus, firmly touch the screen directly on the (+) symbol. Lift the stylus from the screen and the target
will move to a different location on the screen.
5
Repeat step 4 until you have selected all of the (+) symbols.
6
Once you have selected all the symbols, press the [OK] button.
7
Touch the stylus to various points on the screen to verify that the screen is correctly calibrated. If you are not
satisfied with the screen's calibration, press the [Calibrate]) button to begin again.
;
DOING SO COULD RESULT IN FAULTY CALIBRATION
49 - Touch Screen
LED /
AND OR TOUCH PANEL
,
BE SURE TO AVOID TOUCHING THE SCREEN
.
. U
SE OF
.