Table of Contents
Advertisement
TRUE
milk coolers
SETUP
STANDARD ACCESSORIES
SHELF INSTALLATION:
Wire floor racks should be positioned on the floor of the cooler with
legs facing down.
OPERATION
STARTUP
A. The compressor is ready to operate. Plug in the cooler.
B.
Temperature controls are factory-set to give refrigerators
an approximate temperature of 35°F (1.6°C). Allow unit to
function several hours, completely cooling cabinet before
changing the control setting.
Temperature Control Location and Settings.
• Temperature control type will vary upon model and age of
cabinet.
• Mechanical control or electronic control without display:
- Inside cabinet
- Behind cabinet
- Behind front or rear access grill
• Electronic control with display:
- In countertop
- In top louvered panel
- In or behind bottom louvered grill
See website for adjustments, sequence of operation, and more
information.
8
C. Excessive tampering with the control could lead to service
difficulties. Should it ever become necessary to replace
temperature control, be sure it is ordered from your TRUE
dealer or recommended service agent.
D. Good air flow in your TRUE unit is critical. Be careful to
load product so that it neither presses against the back wall,
nor comes within four inches of the evaporator housing.
Refrigerated air off the coil must circulate down the back wall.
NOTE: If the unit is disconnected or shut off, wait five minutes
before starting again.
RECOMMENDATION - Before loading product we recommend
you run your TRUE unit empty for two to three days. This allows you
to be sure electrical wiring and installation are correct and no ship-
ping damage has occurred. Remember, our factory warranty does not
cover product loss!
.
.
www
truemfg
com
Hide quick links:
Advertisement
Table of Contents
