Setup; Standard Accessories - True T-23DT-HC Installation Manual

TRUE
T-23DT

SETUP

STANDARD ACCESSORIES

SHELVING INSTALLATION / OPERATION
SHELF INSTALLATION:
A. Hook shelf clips onto shelf standards.
B. Position all four shelf clips equal in distance from the floor for
flat shelves.
C. Lower front of gravity feed TrueTrac organizers to enable
proper feed.
D. Place shelves on shelf clips making sure all corners are seated
properly.
T-Series
& GDM-5
Airflow
Guard
Shelf
Shelf
Clip
WARNING!
Do not use pliers or any crimping
tools when installing shelf clips.
Altering shelf clips in any way can
lead to shelving instability.
7
Shelf
Standards
Shelf
Pillaster
(I-beam)
SHELF INSTALLATION:
For Proper Shelf Clip Installation Please Read The Following
Instructions.
STEP 2
Bottom tab of the shelf clip will fit tightly. You may need to squeeze or
twist the bottom of the shelf clip to install. (See image 2 & 3).
STEP 3
After installation, the shelf clip will fit snug into the shelf standard.
The shelf clip should not be loose or able to wiggle out of the shelf
standard.
SHELF INSTALLATION TIPS
1. Install all the shelf clips before installing the shelves.
2. Start at the bottom in terms of shelf installation and work your
way up.
3. Always lay the back of each shelf down on the rear clips before
the front.
1
Installing top tab of shelf clip
3
You may need to squeeze or twist
the bottom of the shelf clip to
install
. .
www truemfg com
2
Installing bottom of the shelf
clip
4
Shelf clip installation complete