Setting The Refresh Rate For Your External Monitor; Usb Devices: Connecting - Fujitsu Siemens Computers AMILO Xa 1526 Easy Manual

Connecting external devices
Using the
the external monitor and the notebook's LCD screen.
You can display the same picture on the external monitor and the
LCD screen simultaneously.

Setting the refresh rate for your external monitor

Monitor
The refresh rate must be correctly set so that the image does not flicker.
If the refresh rate set is too high, the monitor may be damaged. Please see the
documentation included with your monitor for the maximum possible refresh rate.
► To do this, select the monitor type under Start – Control Panel – Appearance and
Themes – Display – Settings – Advanced – Monitor.
► Next, select the Adapter tab.
► Adjust the refresh rate and click Apply.

USB devices: connecting

USB ports
On the USB ports you can connect external devices that also have a USB port
(e.g. a printer, a scanner or a modem).
USB devices are hot-pluggable. This means you can connect and disconnect
devices while your operating system is running.
USB 1.x has a maximum data transfer rate of 12 Mbit/s.
USB 2.x has a data transfer rate of up to 480 Mbit/s.
Additional information can be found in the documentation for the USB devices.
Device drivers
Some USB devices will be automatically recognised and installed by your operating
system. However, newer devices will need to be installed using the supplied CD / DVD.
Always follow the instructions supplied with the device to complete the installation.
48
Fn + F3 key combination you can switch back and forth between
► Connect the data cable to the
external device.
► Connect the data cable to a USB
port of the notebook.
10600718746, edition 1