Table of Contents
Advertisement
5 Installation
4.2
Product dimensions
3/8"
3/8"
100
140
d
Unit dimensions
10L U
Dimen-
414 mm
sion (a)
Dimen-
482 mm
sion (b)
Dimen-
504 mm
sion (c)
Dimen-
290 mm
sion (d)
Dimen-
70 mm
sion (e)
Dimen-
270 mm
sion (f)
Dimen-
284 mm
sion (g)
Dimen-
90 mm
sion (h)
4.3
Wall-mounting the product
1.
Drill the holes in the wall for the rawl plugs.
6
e
2.
f
Conditions: The load-bearing capacity of the wall is sufficient, The fixing
g
material may be used for the wall
▶
Conditions: The load-bearing capacity of the wall is not sufficient
▶
▶
5
5.1
1.
2.
Installation and maintenance instructions eloSTOR plus 0020244342_01
Use the appropriate fixing material to secure the
product to the wall as shown in the illustration.
Wall-mount the product as described.
Ensure that wall-mounting apparatus on-site has a suf-
ficient load-bearing capacity. Use individual stands or
primary walling, for example.
Do not wall-mount the product if you cannot provide
wall-mounting apparatus with a sufficient load-bearing
capacity.
Installation
Danger!
Risk of scalding and/or risk of material
damage due to incorrect installation lead-
ing to escaping water.
Stresses in supply lines can cause leaks.
▶
Install the supply lines without tension.
Requirements
Ensure that the product is installed in such a way that it
can be easily accessed during maintenance work.
You must install a safety assembly at the cold water
inlet.
◁
When dimensioning the drain hose for the safety
assembly, note the technical data for the safety as-
sembly.
◁
Install the drain hose for the expansion relief valve
in a frost-proof room while taking into consideration
the minimum downward gradient in order to guaran-
tee that the water drains without any problems.
◁
At regular intervals, ensure that the drain in the
drain hose for the safety assembly is not obstructed.
With standard operation of the product, it is normal
that water flows out of the drain hose on the expan-
sion relief valve.
B
A
Advertisement
Table of Contents
