3M C960 Parts And Service page 7

Model C960 Headset Intercom System
6. Remove the ear cup cover from the ear cup:
a. If the cover is sealed to the cup, carefully cut
through the epoxy seal using a sharp razor
blade.
b. Carefully insert a small, flat-blade
screwdriver between the cover and the ear cup
at the point indicated in Figure 3-5 and pry
the cover out of the ear cup.
7. Remove the ear cup joint. See Figure 3-1.
3M 2001 August
Replacement Parts and Service
Figure 3-3.
Figure 3-4.
8. Carefully withdraw the speaker leads from the
hole in the inner case.
9. Install the new headset speaker and reassemble
the headset in the reverse order of disassembly.
Be sure to correctly align the speaker foam and
speaker gasket with the ear cup cover. Refer to
Figure 3--1.
Not e
3- -7