Table of Contents
Advertisement
J1: VROC Header (full featured RAID 0, 1, 10, 5, using Intel
SSD SKU)
Clear_BTN1: RTC Reset Button for Clear CMOS
3PHD4: BMC Console Port5 Jumper (for BMC Debug)
3PHD7: BMC Console Port5 Jumper (for BMC Debug)
3PHD2: ME Recovery Mode Jumper
Pin
1
Signal
GND
You can reset the CMOS settings by using this button, if you
have forgotten your system/setup password or need to clear
system BIOS setting.
1. Power off the system and disconnect power connectors
from the motherboard.
2. Press the button (Clear CMOS).
3. Reconnect power & power on the system.
NOTE:
After flashing new BIOS, do the following steps:
a. Clear CMOS
b. Enter BIOS setup menu and load Default Settings. Then do
a Save and Exit from setup.
Signal
BMC_COM2_RXD
BMC_COM5_RXD
Pin1-2 closed: BMC COM2 Debug
Pin2-3 closed: BMC COM5 Debug
Signal
BMC_COM2_TXD
BMC_COM5_TXD
Pin1-2 closed: BMC COM2 Debug
Pin2-3 closed: BMC COM5 Debug
Signal
NC
Rpd 49.9 om
Pin1-2 closed: Normal Mode
Pin2-3 closed: ME In Force Update Mode
http://www.tyan.com
2
VCC3_AUX
GND
Pin
1
3
Pin
1
3
Pin
1
3
31
®
VROC, for NVMe
3
PCH_SATA_RAID_KEY
Pin
Signal
2
RXD_2
(Default)
Pin
Signal
2
TXD_2
(Default)
Pin
Signal
2
FM_ME_RCVR_N
(Default)
4
Advertisement
Table of Contents
