NordicTrack COMMERCIAL X32i User Manual page 11

4. Set the Uprights (83) on the Base (74). Make
sure that the hole with the Upright Wire (75)
is on the right side.
Attach the right Upright (83) with two of the
3/8" x 3 1/4" Screws (18) and two of the
3/8" x 2 3/4" Screws (22) that you just removed
and four 3/8" Star Washers (3); do not fully
tighten the Screws yet. Make sure that the
Base Wire (52) is not pinched.
Attach the left Upright (not shown) as
described above. Note: There are no wires on
the left side.
Then, fully tighten the 3/8" x 3 1/4" Screws
(18) and the 3/8" x 2 3/4" Screws (22).
5. Connect the Base Wire (52) to the Upright Wire
(75). The connectors should slide together
easily and snap into place. If they do not, turn
one connector and try again.
Then, remove the tie (A) from the Base Wire
(52), and insert the connectors into the hole (B)
in the right Upright (83).
4
3
5
11
83
18
3
3
75
3
52
74
83
B
A
75
52
22